BARIX EXSTREAMER GOLD Manuel d'utilisateur télécharger pdf (Page 17)

Barix Exstreamer User Manual Version 07.07

Page 15

7.8 Control settings

These settings adjust the control ports, IR source and IR

gateway properties.

UDP command port

Define the port on which the device will receive commands

via UDP.

TCP command port

Define the port on which the device will receive commands

via TCP.

Web server port

Defines the port where the webserver of the Barix

Exstreamer can be reached. If set to

"0"

the default HTTP

port (80) is used.

IR Source

Always select "IR Serial Dongle". "IR IN" is non functional.

IR Gateway

When activated all received IR remote control commands

will be transmitted to other Barix devices IR OUT output.

Leaving the IP address at 0.0.0.0 and setting a valid port

(not 0) will broadcast the IR commands in the LAN.

To direct to a specific device set the IP Address of the

device and the port (

Example: 192.168.0.24:12301

To disable the IR Gateway set the IP address to 0.0.0.0 and

the port to 0.

7.9 Serial settings

This settings adjust the serial port, serial gateway and IR

Dongle LED properties.

Baud rate

Select the serial transmission speed (300 to 115200 Baud).

Data bits

Select 7 or 8 data bits.

Parity

Select no, even or odd parity.

Stop bits

Select 1 or 2 stop bits.

Flow control

Select the type of flow control:

none, software (XON/XOFF) or hardware (RTS/CTS).

Local port

Defines the port on which the serial port can be accessed

for serial gateway application. Only when "Local port" is set

to "0" the serial port can be used as a command interface.

If the active serial gateway is enabled and the "Local port" is

set to a value then this will be the source port of the TCP

connection. On

"0"

a random source port is used.

Destination IP

To have this Barix Exstreamer actively establish a serial

gateway select the destination IP address to the device

where the serial data will be transmitted to (and received

from).Select "0.0.0.0" when the serial port is only used

local.

Destination port

Defines the port for the active serial gateway function (see

destination IP).

Notes

Both settings, "Destination IP" and "Destination port" have

to be set to enable the gateway function.

RTS function

Select the function of the RTS output pin.

On "IR Status" the LED on the connected IR Dongle will

flash upon reception of an IR Remote Control (default

setting). On "activate AVR" RTS is on during streaming and

60 sec after the last streaming. It can be used to activate an

Audio Video Receiver or Amplifier. On "RTS" it can be

used for flow control as usual or as an additional output.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 28 29

Commentaires sur ces manuels

Pas de commentaire

BARIX EXSTREAMER GOLD Manuel d'utilisateur Page 17

Commentaires sur ces manuels